How to Specify a Rear Phone Pocket for a Custom Crossbody Bag
Plan a rear phone pocket around the device, access position, and strap path, then check it on a loaded crossbody bag sample.
Updated September 24, 2026 | 4 min read | Published by Oksaur Outdoor
Start with the phone and the carry position
Decide which phone sizes the pocket must accept, then check where the bag sits when it is worn. A rear pocket can be easy to reach when the strap is across the body but harder to use when the bag is carried at the side. Put the device dimensions and the intended carry position in the brief before discussing the pocket shape.
Set the finished opening and depth
A phone pocket needs enough opening width for the device and enough depth to keep it from sliding out. Specify the finished opening, usable depth, closure type, and any corner clearance. These are inside measurements, so check them on the sewn sample rather than estimating from the outside panel.
Keep the phone apart from the main load
A rear phone pocket has a different job from the main compartment. Note whether it should stay flat against the back panel, include a soft lining, or have a small amount of ease for a case. If the pocket should protect the screen from keys or other contents, record that separation in the construction notes.
Use the MG5001 listing as a starting point
The MG5001 crescent crossbody bag is listed at 35 × 12 × 27.5 cm and includes a rear phone pocket, a front zip pocket, and internal organizer pockets. Its listed capacity covers a phone, small tablet, keys, wallet, and daily essentials. The listing does not give the rear pocket's finished dimensions, so those measurements still need to be confirmed in the quotation and sample.
Check access with the strap adjusted
Load the bag with the phone and the items that normally sit in the main compartment. Try the pocket with the adjustable strap shortened and lengthened, then walk, sit, and turn as the wearer would. Check that the phone can be removed without twisting the bag or pulling against the strap attachments.
Record the approved pocket details
Keep the phone dimensions, pocket opening, usable depth, lining, closure, placement, and strap position in one specification. Add a photo of the approved sample and note any change made after testing. The product listing provides a starting layout, while the quotation and sample confirm the construction for the order.
Discuss a custom crossbody pocket layout
Send the model number, quantity, artwork, destination, and required date. We will reply with the remaining questions needed for pricing and sampling.